Differences

This shows you the differences between two versions of the page.

--- d2:beat_note_detector [2016/01/13 00:44] – [Description] Michael Radunsky
+++ d2:beat_note_detector [2021/08/26 15:26] (current) – external edit 127.0.0.1
@@ Line 12: / Line 12: @@
 Please read [[:limited_warranty|Limited Warranty]] and [[:warnings_cautions|General Warnings and Cautions]] prior to operating the D2-160. All specifications subject to change without notice.
@@ Line 19: / Line 17: @@
 The Vescent Photonics D2-160 high-speed detector has a full 9.3 GHz bandwidth for capturing beat notes between lasers of different frequencies. Simply overlap the master and slave lasers and launch into the included multimode fiber for measuring the relative frequencies of the two lasers. The D2-160 is compatible with both the Vescent [[d2:heterodyne_module|D2-150 Heterodyne Module]] and the [[d2:offset_phase_lock_servo|D2-135 Offset Phase Lock Servo]]. In combination, a true phase lock between a pair of lasers with a user-defined frequency offset can be established. The D2-160 is also compatible with the new [[:ice|ICE]]<sup>TM</sup> (Integrated Control Electronics) architecture. The D2-160 can also capture fast rising edges of laser pulses for timing, triggering, and pulse synchronization.This digitizing high-speed pre-amplified detector converts an oscillating optical signal (a beat note) into an electrical high/low signal. It works great for measuring beat note frequencies or high-speed timing. It is not suitable for measuring optical power or other amplitude characteristics due to the digitized output.
+=====Purchase Includes=====
+  * D2-160 Beat Note Detector
+  * 18 GHz RF SMA Cable (6 ft)
+  * VPN00460 FC/APC to SC MM patch cord (6 ft)
+Also look for:
+  * VPN00410 Hirose-to-D Sub 9-pin (shipped under separate line item; specify for use with D2) or
+  * VPN00475 Hirose-to-Hirose power cord (shipped under separate line item; specify for use with ICE)
 ===== Absolute Maximum Ratings =====
@@ Line 43: / Line 51: @@
 ^Dimensions |  1.38 x 1.25 x ~1.7  | inches |
 </WRAP>
-__=====Operating Instructions=====
+__
+=====Operating Instructions=====
 <WRAP center round important 60%>
@@ Line 51: / Line 60: @@
 ==Powering the D2-160==
+<WRAP center round important 60%>
+Never connect this device to a power supply that is switched on and supplying power.  Always turn off the power supply, make connections to this device, and then re-energize the power supply.
+</WRAP>
 The D2-160 requires +5 VDC and ground to operate.  The power input is via a female 6-pin Hirose connector [[http://www.digikey.com/product-search/en?KeyWords=HR10A-7TR-6SA(73)&WT.z_header=search_go|HR10A-7TR-6SA(73)]]. If you are making your own power cable, pin 4 is +5 V and pin 6 is ground.  Use a 6-pin male Hirose connector [[http://www.digikey.com/product-search/en?KeyWords=HR10A-7TP-6P(73)&WT.z_header=search_go|HR10A-7TP-6P(73)]].  Depending on your order configuration, you should have received a power cable with this connector on one end and either the same on the other (typically for using with ICE products) or a DB-9 connector (with D2-products).