Product Manuals

User Tools

Site Tools

You are here: manuals » waveguide » manuals » ls-15-3005
waveguide:manuals:ls-15-3005

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
waveguide:manuals:ls-15-3005 [2016/01/15 04:18] – Michael Radunskywaveguide:manuals:ls-15-3005 [2016/01/19 00:22] – [Connections and Controls] Michael Radunsky
Line 38: Line 38:
 <color red>WARNING</color> <color red>WARNING</color>
 Do not clean outside surfaces of any Vescent Photonics products with solvents such as acetone. Front panels on electronics modules may be cleaned with a mild soap and water solution. Do not clean optics modules.  Do not clean outside surfaces of any Vescent Photonics products with solvents such as acetone. Front panels on electronics modules may be cleaned with a mild soap and water solution. Do not clean optics modules. 
 +
 +<color red>WARNING</color>
 +The user should NEVER disconnect the  control cable from the scanner or driver while power is applied ("hot swapping"). Since the devices does not have internal pull-downs to ground, any voltage left on the device could permanently damage it, causing reduced throughput, highly degraded beam quality, and large in-plane scattering.
  
 ==Limited Warranty== ==Limited Warranty==
Line 96: Line 99:
 The scanner is packaged with a PM fiber pigtail (see Figure 4) with an FC/PC connector. This is an engineering package and not intended for field use.  Its input must be linearly polarized light with the polarization axis parallel to the FC key.  The scanner is packaged with a PM fiber pigtail (see Figure 4) with an FC/PC connector. This is an engineering package and not intended for field use.  Its input must be linearly polarized light with the polarization axis parallel to the FC key. 
 =====Connections and Controls===== =====Connections and Controls=====
 +<color red>WARNING</color>
 +The user should NEVER disconnect the  control cable from the scanner or driver while power is applied ("hot swapping"). Since the devices does not have internal pull-downs to ground, any voltage left on the device could permanently damage it, causing reduced throughput, highly degraded beam quality, and large in-plane scattering.
 +
 With the power switch in the OFF or down position (see Figure 5) connect the power supply to the wall plug and to the LS-105 back panel (see Figure 6).  Use the provided cable to connect the LS-105 driver to the SEEOR unit.  The unit is now ready to be powered on.  The driver provides up to 110 V to the beam steerer.  Please operate safely. With the power switch in the OFF or down position (see Figure 5) connect the power supply to the wall plug and to the LS-105 back panel (see Figure 6).  Use the provided cable to connect the LS-105 driver to the SEEOR unit.  The unit is now ready to be powered on.  The driver provides up to 110 V to the beam steerer.  Please operate safely.
 Please allow 1 to 2 minutes for the SEEOR to temperature stabilize. Please allow 1 to 2 minutes for the SEEOR to temperature stabilize.