ffc:comb_module_quickstart
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
ffc:comb_module_quickstart [2022/02/11 17:26] – external edit 127.0.0.1 | ffc:comb_module_quickstart [2022/04/01 15:58] – external edit 127.0.0.1 | ||
---|---|---|---|
Line 46: | Line 46: | ||
=====Operating the FFC-CM===== | =====Operating the FFC-CM===== | ||
- | This document provides basic instructions on how to operate the Vescent Photonics SVS Fiber Frequency Comb Module in conjunction with the Vescent SLICE-FPGA. It is important to note that the FFC-CM itself does not come with a built in GUI, and as such communication must be done through the [[link|Serial Command API]] or the [[link|FPGA Software]]. This document will walk through usage of the Serial Command interface including | + | This document provides basic instructions on how to operate the Vescent Photonics SVS Fiber Frequency Comb Module in conjunction with the Vescent SLICE-FPGA. It is important to note that the FFC-CM itself does not come with a built in GUI, and as such communication must be done through the [[ffc: |
=====System Set-up===== | =====System Set-up===== | ||
Line 96: | Line 96: | ||
Finally, go back to the FPGA Software folder in your file explorer and run both " | Finally, go back to the FPGA Software folder in your file explorer and run both " | ||
=====Locking the SVS FFC Module===== | =====Locking the SVS FFC Module===== | ||
- | Before locking, it may be beneficial to familiarize yourself with the full list of API commands for the SVS FFC Module, which can be found [[link|here]], as well as the front and rear panel connections, | + | Before locking, it may be beneficial to familiarize yourself with the full list of API commands for the SVS FFC Module, which can be found [[ffc: |
===Connections=== | ===Connections=== | ||
Line 126: | Line 126: | ||
===Step 5: Verify Supercontinuum=== | ===Step 5: Verify Supercontinuum=== | ||
- | Now that the system is mode locked, switch the monitored output to SC Out and change | + | Now that the system is mode locked, |
< | < |
ffc/comb_module_quickstart.txt · Last modified: 2022/09/23 16:40 by 127.0.0.1