ffc:100
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
ffc:100 [2023/08/17 18:47] – [FPGA Control] Michael Radunsky | ffc:100 [2023/08/17 19:02] – [FPGA Control] Michael Radunsky | ||
---|---|---|---|
Line 75: | Line 75: | ||
====FPGA Control==== | ====FPGA Control==== | ||
- | | {{ : | + | | {{ : |
- | The SLICE-FPGA | + | The two channels of the SLICE-FPGA |
- | + | ||
- | For locking the FFC-100 with the Vescent SLICE-FPGA-II Module, | + | |
- | + | ||
- | If using the SLICE-FPGA, | + | |
====Slow Loop Feedback==== | ====Slow Loop Feedback==== | ||
Slow servo functionality is designed to allow indefinite FOPT locking times despite long-term drifts in the reference laser’s frequency outside the dynamic range of the FFC’s PZT feedback. This is achieved by slow temperature feedback to the oscillator of the FFC, which locks the PZT output voltage to a setpoint voltage near the middle of its dynamic range. To enable the slow servo, first lock FOPT normally, with the DAC 1 slider as close to centered as possible. Next, navigate to the home screen of the FFC-100 and press the “Slow Servo” button at the top of the screen (<imgref ss_home> and <imgref ss_enabled> | Slow servo functionality is designed to allow indefinite FOPT locking times despite long-term drifts in the reference laser’s frequency outside the dynamic range of the FFC’s PZT feedback. This is achieved by slow temperature feedback to the oscillator of the FFC, which locks the PZT output voltage to a setpoint voltage near the middle of its dynamic range. To enable the slow servo, first lock FOPT normally, with the DAC 1 slider as close to centered as possible. Next, navigate to the home screen of the FFC-100 and press the “Slow Servo” button at the top of the screen (<imgref ss_home> and <imgref ss_enabled> |
ffc/100.txt · Last modified: 2023/08/22 23:46 by 127.0.0.1