Differences

This shows you the differences between two versions of the page.

--- d2:offset_phase_lock_servo [2018/11/14 17:45] – [Right Side Panel] Michael Radunsky
+++ d2:offset_phase_lock_servo [2018/11/14 17:47] – [Front Panel] Michael Radunsky
@@ Line 72: / Line 72: @@
 |**VCO drift**|  200  |  ppm/°C  |
 |**PFD Noise**(( See [[#calculating_phase_noise|Calculating Phase Noise section]] for a full description))|  -213  |  dBc/Hz  |
-|**ω**<sub>**I**</sub>** **(Integral/Prop. zero)|  4,8,16,32,64,125,250,500  |  kHz  |
+|**ω**<sub>**I**</sub>** **(Integral/Prop. corner)|  4,8,16,32,64,125,250,500  |  kHz  |
-|**ω**<sub>**D**</sub>** **(Proportional/diff. zero)|  16,32,64,125,250,500,1000,off  |  kHz  |
+|**ω**<sub>**D**</sub>** **(Proportional/diff. corner)|  16,32,64,125,250,500,1000,off  |  kHz  |
 |**ω**<sub>**HF**</sub>** **(high freq. cutoff pole)|  0.25, 0.5, 1,2,4,8,16,off  |  MHz  |
 |**Servo Output Range**|  ±10  |  V  |
@@ Line 179: / Line 179: @@
 **Coarse Gain (eight-position switch)**
-The COARSE GAIN sets the overall proportional gain of the circuit without changing the location of any zeros or poles in the loop filter transfer function. The coarse gain adjusts in steps of 6 dB from 0 dB to -42 dB.
+The COARSE GAIN sets the overall proportional gain of the circuit without changing the location of any corners or poles in the loop filter transfer function. The coarse gain adjusts in steps of 6 dB from 0 dB to -42 dB.
 **Servo Output**