User Tools

Site Tools


d2:laser_controller

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
d2:laser_controller [2022/02/11 17:37] – external edit 127.0.0.1d2:laser_controller [2022/02/11 17:40] – external edit 127.0.0.1
Line 207: Line 207:
 Both temp control loops can be toggled with a board-level switch located under the PID tuning switches. If you are experiencing problems with either of your temp loops, please toggle this switch off and then on again, as it's possible for the switch to get bumped into an intermittent position where it looks on, but is off. The most common symptom of this issue is that the faulty temp loop's front panel LED will turn red, but this does not always happen. Both temp control loops can be toggled with a board-level switch located under the PID tuning switches. If you are experiencing problems with either of your temp loops, please toggle this switch off and then on again, as it's possible for the switch to get bumped into an intermittent position where it looks on, but is off. The most common symptom of this issue is that the faulty temp loop's front panel LED will turn red, but this does not always happen.
 </WRAP> </WRAP>
 +
 +<imgcaption standby_switch|The location of the control switches for T1 and T2.>{{ :d2:d2-105:standby_switch_loation.jpg?600 |}}</imgcaption>
  
 **Temp Lock (Dual position switch)** **Temp Lock (Dual position switch)**
d2/laser_controller.txt · Last modified: 2024/03/27 15:33 by Thomas Bersano