Differences

This shows you the differences between two versions of the page.

--- d2:laser_controller [2021/08/26 14:26] – external edit 127.0.0.1
+++ d2:laser_controller [2022/02/11 17:34] – external edit 127.0.0.1
@@ Line 207: / Line 207: @@
 The temperature servo input is summed to the T2 temperature set point signal and can be used to make electronic perturbations to the laser diode temperature.  The Temp Servo Input, has two settings: "Low" and "High" gain. The default settings is "Low" but can be changed by a switch accessible on the right side panel. See <imgref VPN00267>.
+<WRAP center round box 570ptx>
+Both Temp control loops can be toggled with a board-level switch located under the PID tuning switches. If you are experiencing problems with either of your temp loops, please toggle this switch off and then on again, as it's possible for the switch to get bumped into an intermittent position where it looks on, but is off. The most common symptom of this issue is that the faulty temp loop's front panel LED will turn red, but this does not always happen.
+</WRAP>
 <WRAP center round box 570px><imgcaption VPN00267|Temp control board with T2 Temp Servo Input gain switch circled>[{{ d2:d2-105:vpn00267.gif?nolink&550 | filler text }}]</imgcaption></WRAP>
@@ Line 254: / Line 259: @@
 {{ :d2:d-sub_power_pinout.jpg?nolink&150 |}}
+While it is infrequent, the D2-005 power supply may occasionally radiate noise from the side of its chassis onto nearby electronics. This only occurs in some system configurations, and will appear as a signal at the frequency of your mains electricity (typically either 50 Hz or 60 Hz). This noise can easily be removed by moving the D2-005 at least 18 inches (45cm) away from other electronics, rotating it 90° such that the sides of the D2-005 face away, or by moving the entire power supply to a different shelf. To accommodate this, all D2-005's are shipped with a 5' DB9 cable as of January 1, 2022.
 **Laser Enable**