Differences

This shows you the differences between two versions of the page.

--- d2:laser_controller [2018/10/16 21:07] – [Table] Michael Radunsky
+++ d2:laser_controller [2018/11/26 19:53] – Michael Radunsky
@@ Line 127: / Line 127: @@
 **Fine Current (knob)**
-The fine current adjusts the diode injection current by ½-1 % of the course control setting.  Use this control for fine positioning of the laser frequency prior to locking.
+The fine current adjusts the diode injection current by ½-1 % of the coarse control setting.  Use this control for fine positioning of the laser frequency prior to locking.
 **Course Current (Scale Dial)**
@@ Line 220: / Line 220: @@
 An 8-pin Hirose connector (see <tabref TECconnectortable> for identity of connectors) carries the signals for the temperature control of the Laser module.  The wiring diagrams are shown in the table below, where 1 (2) refer to stage 1 (2) temperature control, which stabilizes the Laser Housing (Laser Diode). Rth and Rth_Rtn are the two ends of a 10 kΩ [[http://www.analogtechnologies.com/ath10kr8.html|Analog Technologies ATH10KR8 Thermistor]].
-<WRAP round center box 230px>
+<WRAP round center box 230px><tabcaption TEC_connector_pinout| TEC connector pin out>
 |  **Pin**  |  **Signal**  |
 |  1  |  TEC1+  |
@@ Line 230: / Line 230: @@
 |  7  |  Rth2  |
 |  8  |  Rth2-RTN  |
-</WRAP>
+</tabcaption></WRAP>
 <WRAP round center box 320px>